Powerlifting Heads-Up

I drilled a hole through the top in the center of one side of the cage.

I bolted one piece of 1/4 x 1 and 1/2 inch bar stock on each side of the hole,
set-back to align cable on pully.

I bolted a pulley between the two pieces of bar stock.

I did the same thing off of the front on a slight angle to assure cable clearance.



	Pulldown Rigged on Powercage I drilled a hole through the top in the center of one side of the cage. I bolted one piece of 1/4 x 1 and 1/2 inch bar stock on each side of the hole, set-back to align cable on pully. I bolted a pulley between the two pieces of bar stock. I did the same thing off of the front on a slight angle to assure cable clearance. Next... (click here) © Joe Skopec 2005

Pulldown Rigged on Powercage